"1000" Watt DIY Light for Indie Film and Photography

I am an indie film maker/photographer. If you want to see examples of the light in action for video, visit The Proper Gents. This is built out of oddball items that can be found around the house and at your local home improvement store. I encourage you to take a look around your house and see what you can use and recycle prior to purchasing anything.

I was inspired by Griffin Hammond and his 800 watt light. Here is his instructable https://www.instructables.com/id/DIY-video-light-80...

I wanted to up the ante because I really needed a ton of light.

*Disclaimer- Please do not attempt if you don't understand electricity and how to properly wire a circuit. Take some time to understand how electricity works before attempting. I am a professional at what I do, but you are responsible for wiring that you do. This is a strictly indoor light. If you would like to waterproof your light, additional steps need to be taken to keep the water out. Please Advise.*

*"1000" Watts* is just the combined supposed watt numbers of the bulbs that I purchased, not the actually total amount of light. Please Advise*

I had this red box with a lid on it. I painted the inside of the box white to help bounce light out. I have wieght holding down a piece of wood on each side of the plastic on this box I had. I used double stick tape and silicone. This wood will help secure the flag pole mount to the box and make everything much more structurally sound.

I used plastic cheap light fixtures with Y splitters. The Y splitters had a round base. I don't have a photo, but I used a scroll saw to cut the sides to slim down the fixtures. This is just a dry fit to check if I had enough room. It was a perfect fit. These can be purchased at most home improvement stores.

*Warning* Please do not attempt to wire anything electrical if you don't have a good understanding. Please seek professional help and assistance until you DO know what you are doing. There are plenty of resources online and on instructables.com to help inform you.

I am wiring them so I can independently turn off the bulbs. I looked into installing a dimmer, but the cost involved was way out of budget. If I need less light, then I can turn individual bulbs off. The wire is repurposed from an old cord.

I used a flag pole mount and this is by far the cheapest and most effective way to mount the box. Its adjustable and very strong. You will find them at most of your big box hardware stores

I chose these switches because they look cool, they give a satisfying click, and they are the cheapest ones at the store I was at! I used a sheet pan to house the switches and cover up the wires to give a neat appearance. It might be DIY, but that doesn't mean it has to look like it is DIY! Make sure the sheet pan is insulated from all wiring or you will be in for a SHOCKING surprize. Also do not use this in any rainy/wet situation.

This puts out ample light for a key light. The bulbs and white box interior give a nice soft light that really helps out your camera and your shot. It allows you to boost your shutter speeds which is exactly the reason I built this. I hope you enjoyed my first instructable!

Get in touch with me at http://www.curtosnoir.com