1st Place Award Winner Cake

This is a 1 tier cake that was made to celebrate the 1st place winner, but it is not edible because is not an actual cake is just a model cake from the computer.

Onshape

The circle has to be above 6 inches so the size of the cake can be big.

The extrude has to be above 2 inches so the height of the cake can be tall like an actual 1 tier cake.

Set the top plane on the top of the model so there is decorations on top of the model of the cake.

Use the sketch that was previously made and add a circle in the middle with a diameter of 00.2 so it can be a candle.

The candle has to be extruded to around 1 inch so the candle can stand out.

Add on a chamfer on top edge of the candle so it looks like an actual candle.

The candle fire can be in any kind of form, but I made mine looks like it just raised up.

Extrude the fire to 0.15 inches so it looks like raised up.

Add a fillet to the top edge of the model and the bottom edge of the model so it looks like there some frosting on it.

The title of the is 1st Place Award and the font is tinos.

The title is extruded by 0.01 inches, so it looks flat.

I added a medal for a decoration on the cake so it wouldn't look bland on the top.

I extruded each part of the medal apart so it wouldn't look the same. They are extruded by 0.01 inches.