3 Easy Steps to Make a Voltage Divider

For another project of mine, I needed a voltage divider from 12V to 5V. Looking on internet I found many fancy, complicated, powerful, etc schematics. So, I decided to build very simple one. Is not my original idea, you can find it on internet as well but was looking some time for it. I like it because is simple and I decided to share it with community.

- 15k resistor

- 10k resistor

- wires

- soldering

Strip three wires on both ends. Solder the two resistors at one end and one wire between them. Solder the other two wires to free ends of resistors. That's all folks.

15k resistor free end is to be connected to 12V, 10k resistor free end is to be connected to GND and middle wire is the 5V output.