3D Printed AT-AT

We made an AT-AT because it went with tinker and design. Because you can take it apart and build it.

We used tinker cad, MakerBot, and a MakerBot sketch.

First, we had to think of four ideas. Then, we had to take measurements. After that, we started creating it in tinker cad and changing it to see how well it would go.

Then, we got a MacBook and sent it to MakerBot. We had to send them separately to fit them in the 5x5x5 work plane. We had to change the name of the file so it wouldn't show the legs twice when we pressed animated

Then we had to get a thumb drive and send it to the MakerBot sketch. We waited for it to print.

Finally, we took it off the breakaway supports. But, when we tried to take one of the legs off it snapped. But, it just turned out not very well.