3D Printed Dice

by andrewm3041 in Workshop > 3D Printing

786 Views, 2 Favorites, 0 Comments

3D Printed Dice

3d printed dice.png

The materials you will need for this project are

-A Computer

-A 3D Printer

-PLA

-Autodesk or Tinkercad

Step One

autodesk pictues.png

Open up autodesk and select new part or part. Select sketch and press rectangle. It will then tell you to choose a plane. Choose the XY plane. Then make a 1in by 1in square. After that go to 3D model and extrude it into a 1x1x1 cube.

Step Two

autodesk pictues 2.png

Then make a 1in by 1in square. After that go to 3D model and extrude it into a 1x1x1 cube.

Step Three

autodesk pictues 4.png

Go back onto sketch and select circle and make a circle on the top. Then dimension it to the middle of the cube. After that press finish sketch and go to extrude and extrude in .1 inches. Do this on all sides of the cube to make the numbers of the dice.

autodesk pictues 5.png

The next step is to round the corners. You can do this by going to 3D model and clicking fillet and keep it on .125. Once its on that click all the edges and press the check mark when you are done. Now you are ready to print the dice just save it onto your flash drive and you're good to go.