3d Printable Multi Tool

This is a 3d printed multi tool. Not only does this include wrenches and a ruler it includes a retractable knife, a USB drive, and possible a thermometer. I use this almost everyday, whenever I open a box, need to cut something, or need to tighten so screws.

What will you need?

• At least one 3d printer
• at least one spool of PLA filament
• A USB drive component
• A box cutter blade
• Super Glue
• Slicer where you can control settings
• A snack

Where to download the STL files?

• You can access the STL files on Thingiverse or click the attached STL file.
• Thingiverse
  • Click this link and it should bring you to the correct page
  • It should bring you to a page with the title multi-tool
  • Download the "Thing File"
  • Then upload it to you slicer and use the instructed settings
• Attached STL file
  • Click the download button on the STL file below
  • Then click this link to see the print settings
  • Upload the file to your slicer and insert the print settings.
• Proceed to the next step

Printing the Parts

• Download the STL files like in the previous step
• Set up the proper setting
• You can find them at this link
• Make sure you have a properly calibrated print bed
• You also need very good bed adhesion
• If you want it to also be a thermometer, use thermo-sensitive filament
• Once it is printed, remove it carefully from the bed
• You can then sand it as you wish

Adding the box cutter blade

• You need to be very careful
• Slide the blade in where it would come out without cutting yourself
• It will get caught when you get to the first notch
• Pull up the locking mechanism and continue sliding
• Slide until the blade is fully covered and locked in
• BE CAREFUL it is a sharp knife, use at your own risk

Inserting the USB Component

• Sand off the outside of plastic
• Make it as smooth as possible
• Put a drop of glue on the back edge of it
• Slide it through
• let it sit and dry

Doing next

• Show your friend, please direct them to this page
• Also please post your make on the Thingiverse website
• If you have any questions, please feel free to ask in the comments