Acrylic Light Display

by Ty2017 in Circuits > LEDs

4382 Views, 86 Favorites, 0 Comments

Acrylic Light Display

2017-07-07 08.54.32.jpg

How to make an acrylic light display.

Supplies

image.jpeg
Scissors
Hot glue
Ruler
Engraving tool
Acrylic sheet
12v batteries tholder
Adhesive LED strip
Wire
On/off switch
Soldering iron
Cardboard
Duct tape
Pictures/template

Engrave

image.jpeg
image.jpeg
image.jpeg
image.jpeg
Tape your picture under the acrylic sheet. Use the engraving tool to trace over the design.

Build a Base

image.jpeg
image.jpeg
image.jpeg
image.jpeg
image.jpeg
image.jpeg
Use cardboard to make a base and hot glue all the sides together. The base will hold up your plastic sheet and contain the electronics. Make a slit in the top for the plastic to go into. I also cut a small hole for the on/off switch and then covered the base in duct tape to make it look nicer.

Electronics

image.jpeg
image.jpeg
image.jpeg
image.jpeg
image.jpeg
2017-07-07 08.55.07.jpg
Solder the battery and switch leads, positive to positive, neg to neg. Put the let on a piece of cardboard that can go inside the base. Position it under the plastic sheet as close as possible. Add batteries.