Mad Scientist Lab Gear: Aeration Tubing
by The Ideanator in Workshop > Science
4133 Views, 12 Favorites, 0 Comments
Mad Scientist Lab Gear: Aeration Tubing
A short I'ble for making aeration tubes for various projects involving dispersing gasses in liquids.
Disclaimer (why? Because People Can Be Idiots)
Standard procedure disclaimer here:
I AM NOT RESPONSIBLE FOR YOUR STUPIDITY, IF YOU F*CK UP, ITS YOUR FAULT.
This includes:
-you injure yourself/others
-the cops or Homeland Sec. claim you're up to no good(not likely, but possible)
-you kill yourself/others (sad, but also could happen)
-I'm not paying your hospital/funeral bills
-however, if you stab yourself with the nail with serious harm inflicted, I will personally bear no responsibility for your actions.
I AM NOT RESPONSIBLE FOR YOUR STUPIDITY, IF YOU F*CK UP, ITS YOUR FAULT.
This includes:
-you injure yourself/others
-the cops or Homeland Sec. claim you're up to no good(not likely, but possible)
-you kill yourself/others (sad, but also could happen)
-I'm not paying your hospital/funeral bills
-however, if you stab yourself with the nail with serious harm inflicted, I will personally bear no responsibility for your actions.
Tools
you will need:
clippers
nail
vice
hot glue gun (with glue)
clippers
nail
vice
hot glue gun (with glue)
Materials
You will need:
surgical tubing
surgical tubing
1) clip tube to desired length
2) turn hot glue gun on
3) put nail in the vice with the pointy end up
4) pull tube down on nail, punch hole
5) repeat 4 until satisfied
6) hot glue gun hot yet? fill the lower end of tube with a small amount of hot glue and wait until hard
7) use it however you want
2) turn hot glue gun on
3) put nail in the vice with the pointy end up
4) pull tube down on nail, punch hole
5) repeat 4 until satisfied
6) hot glue gun hot yet? fill the lower end of tube with a small amount of hot glue and wait until hard
7) use it however you want