Altoid Pill Box

This instructable teaches you how to make a 6-day pill box out of an altoid container!

Required Materials: altoid box, scissors, cardboard, tape, sharpie(optional) and ruler

Measure the inside of the altoid box’s height, length, and width with the ruler.

**Tip** It is easier to measure in centimeters to get an even number.

Measure, with ruler, the first piece of cardboard and make sure it matches the box’s horizontal length and box’s height.

After measuring, use the scissors to cut the first piece of cardboard so it matches the measurements from the above step.

Measure, with ruler, the other two pieces of cardboard and make sure it matches the box’s vertical length and box’s height.

Place the longer piece of cardboard horizontally in the middle of the box.

Cut, with scissors, these pieces of cardboard so they match the above measurements.

After cutting the smaller pieces of cardboard to the exact measurements, cut them again in half. Cut the smaller pieces of cardboard exactly in half. 

Mark the long piece of cardboard in thirds.

**Tip** Mark every 3 centimeters using ruler for accurate measurements.

Tape the small pieces of cardboard to each side of the big pieces of cardboard at the ⅓ intervals on the big cardboard.

Make further adjustments with the scissors so cardboard fits snuggly to the sides of the altoid box.

Tape all cardboard to the sides of the altoid box.

Optional: Use sharpie marker to mark days of the week in boxes of pill box.