Altoids Mini BBQ Pit
Get your parts together.
1. Altoid can
2. 5 long bolts with two nuts for each bolt.
3.flat head Screw driver
4. Drill bit bit slightly larger that bolts
5 Optional heat resistant paint for BBQ pits.
1. Altoid can
2. 5 long bolts with two nuts for each bolt.
3.flat head Screw driver
4. Drill bit bit slightly larger that bolts
5 Optional heat resistant paint for BBQ pits.
Bending the Hinges
Use the screw driver to bend the hinge.
Separate the Lid and Can Separated
A look at the two halves separated.
Drilling Holes
drill several small holes using a drill bit.
Drilling Leg Holes
there shall be 4 holes slightly smaller than your bolts.
Leg Holes
inside look at the holes.
Preparing Legs
but 4 nuts on your 4 bolts as picture shows.
Putting Legs On
put a nut on the bottom side and the top side.
Install Legs
Ad nut to bolt and adjust down a 1/4 inch.. Push the bolt through the hole and attach the remaining nut. There will now be a nut on each side of the bottom of the mini BBQ.
Putting Together
flip the top and lay it on the bottom half.
Adding Handle
drill another hole to the right so you can lift the top half and feed the fire.
Painting
use a special kind of spray paint that is fire proof.