Archery Bow Rack

A 2 x 3 foot display rack for your archery bows with bottom bin to hold equipment such as pin sight, finger rollers, armguard, and arrow quiver. Use two 8 foot boards to account for width of the blade when cutting.

Wood Products:
(2) 1x4, 96", Board

Hardware/Supplies:

(22) 1 1/4" Kreg Screws

(6) Shelf Pins, 5mm

Tools:

Kreg Pocket-Hole Jig

Kreg Shelf Pin Jig

Drill

Miter Saw/Saw

Tape Measure

Make your 3' and two 2' cuts from the same boards. Drill your pocket holes for 3/4" depth as shown. Center or offset the pocket holes for the face boards.

The image is shown from rear of the rack to view pocket holes. Secure the Top facing board to the cross brace. The Top facing board will be flush with the mounting wall. Secure the Bottom facing board with the bottom board. The Bottom facing board is opposite from the mounting wall to create a bin.

Secure sides to the cross braces.

Archery bows are not made the same. Mark pin holes against your bow(s). Use scrap 1x4 as a spacer for the Shelf Pin Jig fenced at 1". This will align the holes to the side boards.

This rack was finished with stain and shellac. Mount to wall with 3" screws through Top facing board into wall studs.