Avacado-it

by CulinaryReinvented in Workshop > 3D Printing

209 Views, 0 Favorites, 0 Comments

Avacado-it

IMG_9531.jpg

This device will help make it possible for those with the ability to use one hand, to cut an avocado.

Insert Avocado Into Device

IMG_9508.jpg

Close Device and Gradually Insert Pins on Both Sides Slightly

IMG_9509.jpg
IMG_9510.jpg
IMG_9511.jpg

Set Device Upright on Hard Surface and Insert Knife Straight Down Against Device

IMG_9512.jpg
IMG_9513.jpg
IMG_9514.jpg

Cut Avocado Around the Pit

IMG_9516.jpg

Place Device on Table With Hinges Up and Continue Cut

IMG_9517.jpg

Remove One Pin, Open Device and Flip Avocado

IMG_9518.jpg
IMG_9520.jpg
IMG_9519.jpg

Reinsert Pin and Finish the Cut With Hinges Faced Up

IMG_9523.jpg

Press Down As Far As Possible on Both Pins

IMG_9521.jpg

Open Device Remove the Two Halves, Press Down on Half With Pit and Remove the Pit

IMG_9524.jpg
IMG_9525.jpg
IMG_9526.jpg

With 2 Halves Still Attached to Pins, Cut Avocado Into Slices Pressing Against Hard Surface

IMG_9527.jpg
IMG_9528.jpg

Printing Instructions

Download .stl file, print on 3D printer (preferred filament type is PETG), once printed snap hinges together.