Awesome Duct Tape Wallet

Note- This is my first actual instructable so don't be too harsh

Also after i make it neat and add decoration i will add the new pictures

This is a wallet I made for myself based off of one i previously made. It has 1 main pocket, 1 pocket for an ID card and 6 pockets for normal cards and 1 secret pocket for anything that wouldn't fit in the card pocket.

also all measurements do not have to be perfect.

If you like it rate it and comment. if you make it post pictures.

Duct Tape (any color you want)
Scissors
Exacto Knife
Ziploc Bag
Tin Foil or Paper
Ruler
Surface to Cut on
Marker or Pen

First cut out a piece of tin foil or paper 8 6/8 inches by 3 5/8 inches

Then Cover Both Sides With Duct Tape and put this piece to the side

This is the inner piece that will combine with the outside piece to form the main pocket.

This step is the same as the first step except the measurements are different.

First Cut Foil or Paper in a rectangle with the dimensions 8 5/8 inches by 3 1/2 inches

This step will show how to make the pieces that will form the card pockets.

First cut two - 4inches by 3 1/2 inches pieces of foil or paper then cover with duct tape.

Then cut six - 1 7/8inches by 3 6/8 inches of foil or paper then cover in tape.

First cut out a piece of foil or paper 6 3/8 inches by 3 1/2 inches.

Lay this so the long way is horizontal.

Then fold it 3 6/8 inches from the right side to form a right angle

after this apply duct tape only to the smaller side

For this step you are going to need the Ziploc bag.

First Place your ID Card into the bottom right corner of the Ziploc bag (picture 2)

Second trace around the left and top edges of your card but leave a good amount(picture 3)

Third Cut just inside of the line you drew(picture 4)

Fourth Trim the bag so it fits on the piece you made in the previous step(picture 5 and 6)

Fifth trace a small semi-circle and cut it out so you can remove your card with ease(picture 7)

Sixth now tape this onto the piece that you made in step 5(look at picture 6 again)

Now you are going to need one of the 4 inch by 3 1/2 inch pieces and the piece you finished in the last step.

First lay the piece with the clear pocket face down

Then take the other piece and lay it on top of it(see picture 2)

Tape the two pieces together(see picture 2 again)

Get The Two Pieces from step 2 and 3

Lay them on top of each other with the bigger one on the bottom(see picture)

Then Tape them together on the left side the bottom and the right side(see picture again)

Now go get all those smaller pieces we made before and the ID Pocket

First Lay the 4 inch by 3 1/2 inch piece on the left side and the ID pocket on the right side(picture 1& 2)

Second tape these pieces down(picture 1 again)

Third take the little pocket pieces and get a piece of tape bigger than it. then take the pocket piece and place it in the middle of the tape. then tape it over the 4 inch by 3 1/2 inch piece and the ID Piece (see pictures 3,4,5 and 6)

Now you're done

Now you are done.


If it is messy go over the messy places with tape to give it a neater look.

Then you can go ahead and decorate it with multiple colors of duct tape or stickers or anything else you can think of.