Camp Chair Repair, Using Instamorph

Some chairs are held together with plastic rivets. They often break or get lost. Grab some Instamorph, boil some water, and fix it, in just a few minutes.

Instamorph + hot water = moldable plastic (Heat gun/hair dryer is optional, but useful.

Instamorph instructions

Canning jars work great, but any glass should work, as long as it can handle the boiling water. Being careful not to burn yourself, roll the hot Instamorph into a snake that fits through the holes.

While it's still hot, (reheat, if necessary) put the Instamorph through the grommet and hole in the chair, and smush. Make sure the Instamorph is flared, at the top and bottom, to secure the two parts together. You can always add and remove material, as you need.

Remember, the Instamorph needs to stay below 140°F/60°C, so a hot car, or direct sunlight on a really hot day might soften it up, again. Look, before you sit!

Thanks, and stay safe. =]

-Bimmy

~~~~~~~~~~~~~~~~

The Phoenix Asylum

Artist/Maker Co-Op

Boulder, Colorado

~~~~~~~~~~~~~~~~