Canon N3 Socket Made easy.
Materials needed:
1 - you can get a local electronics store, 1 as the SIP socket.
2 - Cyanoacrylate adhesive.
3 - Rasp or sand
4 - 2 cm, with a heat shrinkable tube.
5 - a little patience.
1 - you can get a local electronics store, 1 as the SIP socket.
2 - Cyanoacrylate adhesive.
3 - Rasp or sand
4 - 2 cm, with a heat shrinkable tube.
5 - a little patience.
Construction:
1 - One side of the socket is thinned, with a rasp (thickness should be approximately 2.3mm)
2 - from the socket, the two parts and a piece is cut with a cutter.
3 - diluted surfaces adhered to each other, exactly centered.
4 - The glue hardens, the test shall be attached to the socket on the camera.
5 - If there is a problem, use the tip of solder wire.
6 - with the heat shrinkable tube, on the cable, turning off the narrow connections.
7 - that's all
2 - from the socket, the two parts and a piece is cut with a cutter.
3 - diluted surfaces adhered to each other, exactly centered.
4 - The glue hardens, the test shall be attached to the socket on the camera.
5 - If there is a problem, use the tip of solder wire.
6 - with the heat shrinkable tube, on the cable, turning off the narrow connections.
7 - that's all
Final
Finished Socket,
For the following Canon models can use this socket.
10D, 20D, 30D, 40D, 50D, 60D, 5D, 5D Mark2, 7D, 1D, 1Ds
For the following Canon models can use this socket.
10D, 20D, 30D, 40D, 50D, 60D, 5D, 5D Mark2, 7D, 1D, 1Ds