CardBoard Kids Toy

This toy is a toy where you try to fit the correct shapes into a box. This is how you would make it out of cardboard.

You will need glue, cutting device, a ruler, and some cardboard.

You will need to get a Card Board Box and cut off the flabs.

Next get a tool that will cut a box, and cut out your top and bottom to the toy.

After you finished cutting out the top and bottom of the toy, cut shapes into the top piece and side of the box. (You can spray paint if you want).

Before making your 3d shapes, you need to get your cutting tool and cut two lines on the side of your box. That will make you your door to get the shapes out of.

To make the 3d shapes your will need to measure the sides of the shapes you already cut out on the top and bottom of the toy, then cut out shapes in that size. After you have all the 1 dimensional shapes hot glue them all together. Like the pictures above.

After finishing the 3d blocks you might need to trim the shapes on the top and side of the box, to make sure the 3d blocks will fit.

You need to get your glue gun and glue on the top and bottom to the box. After that your product is done