Center Table

In this tutorial we will make a center table using fusion 360.

This is an easy project to perform and comprises three parts.

We will start with the base that consists of two pieces.

First we have to make a rectangle with 500 x 700 mm constrution lines. At the top, we draw lines with a distance of 120 mm and 30 mm.Then down to 35 mm.

Next, we draw two 140mm lines on each side, slightly set back from the sides.

Then connect the upper rows with a 350 mm circle. We cut parts that we don't use.

We connect the top and bottom with "conic curve".

The two parts are the same except for the holes that will be used to connect them. The dimensions of these in A are 100 x 90 mm and 100 x 140 mm B.

these are in the lower half of the circle and the upper half of the base.

We extruded and then use both give a thickness of 100 mm.

We will make a 780mm circle for the last part.

Then extrude to 50 mm and then make boxes 100 x 120 mm in the same plane. Will use after construction lines 130 mm to position the rectangle, also use the central rectangle funsion.

We use extrude with -35 mm in the rectangles.

If you want, you can insert an image and use Fit Point Spline to achieve the design you want. Change it too using appearance (modify).

Finally you end up joining parts using joint(Assemble).