Change Furbys Clock With RadioWaves

Circuit-bending a furby. This hack make it possible to control furbys Clock speed with Radio Waves from Home appliances.

There is a quartz resonator (36.768kHz?) on the bord behind eyes.
Remove it with a soldering iron.

Solder 2 wires (about 20cm) on the board where a quartz resonator was.

Cut it in half.

6P toggle SW,   I named this SW as "Magical SW" in my video.

(left side) the quarts resonator <- STEP1
(center)   purple lines are soldered on furbys board <- STEP2
(right side) Aligator Clips <-STEP3

when you close clips to Home appliances...your Furby may act violently or slowly !?
Have Fun !