Cheap Selfie Light

How to make cheap Selfie light from 20 W Tubelight

1. Soldering Iron

2. Fevi-quick

3. Plastic

4. Hacksaw blade

5. Wires for joining

6. Double-side Stickers

7.Plier

First Take 20W Tubelight and Measuring Tape

Measure Tubelight in Cms. Here my tubelight length is 118 cms

Now Divide into 4 pieces ,Mark in Tubelight with Marker

=118/4

= 29.5 cms

Use screw driver and gentle push the nob

the Side cover fall off.

Use same technique in opposite side too.

Caution: Remove the Plug and wait for 10min until all current in capacitor looses.

Now Desoldering + terminal and - terminal of LED strip.

Slide of Top cover and separate from base.

then pull LED + wire and get the circuit.

keep it separate for final sodering

1. Cut down both bottom holder and top protective Plastic into 29.5 cms

2. Scrub the LED strip and make sure Copper easily visible from all 4 pieces.

3. use wires and soldering the wires similar to original layout.

4. soldering both ends

5. Add LED driver circuit solder + LED terminal and - Led terminal similar like original Wiring

1. After careful soldering of all 4 pieces.

2. arrange like rectangle.

3. use Fevi-quick and paste backside some plastic for support.

4. use 45 degree L angle plastic for support all 4 corners inside of Selfie light.