Computer Build

Full instructions on how to build a computer with the build kit from Mr. Rilley's IT Class 2015, Trevor Smith, Josh Oaks.

Line up the boxes on the bottom between the pins with the case you are putting it on gently. Don't put any pressure on it.

Attach the clips on the bottom sides to the motherboard then close down the switch.

Have the ends of the DIMM slot opened up. Next, line up the gap in the bottom of the ram stick to the slot. Then slide the ram down into the slot. Keep straight then push down until the ends click shut.

Place in the corner of the case with a rectangular opening then slide in then screw.

Place it against the edge, fitting the ports through the case(shown in next step). Put in screws in each hole, should be 6.

There are slim metal parts on the side of the case that you need to brake one off that lines up to the PCIe slot on the motherboard to the case. Place the graphics card in the PCIe Slot on the motherboard. Hold open end piece to place it in, line up the bottom just like how you installed the ram. Make sure it fits perfectly.

Remove the black holder piece by turning red piece counter clockwise. Then slide in the hard drive so that the plug in parts are facing out. Do not slide it all the way in, line up the screw holds with the case.