Cutting Avocado Model
Using, assembling, and printing the avocado model.
Placing the Model
Set the model onto the edge of the table top.
Adjusting the Model
Insert the screw at the bottom of the model and tighten it until it is firmly clamped onto the table.
Placing Avocado
Place the avocado in the tray in between in the two prongs.
Cutting the Avocado
Cut the avocado using a knife in between the two prongs.
Flipping and Placing Avocado
Take the avocado out of the tray and flip it around to the uncut side. Then put the avocado back inside the tray.
Cutting Whole Avocado
Use the knife to cut the rest of the avocado in half. Take out the two pieces of avocado.
Assembling Instructions
The model comes in two pieces, the main device to clamp onto the table and a screw. Insert the screw at the bottom of the model and twist to tighten and clamp the main device onto the table.
Printing Instructions
Open the STL file in a 3D printing software. Rotate the model so the clamp bar is not touching the baseplate. The software should automatically connect to a 3D printer if the file opens. You can then click print and wait for the model to print.