DIY Bicycle Mount for GPS Garmin Etrex 10, 20 and 30. (maybe Other Models Too!)

Before starting I must apologize for possibles errors in writing. My English is bad!

So... let's go started!

- empty oil bottle (finish line 4oz, 120ml)

- ziptie bracelet

- cutter

- electrical tape

- bicycle inner tube (to make rubber band)

- paper and pen.

Draw the border of the device on paper and cropping.

- Utilizing the template, cut out the bottle carefully until the moment that the device fit in the indented space.

- Do the same thing on the bottle bottom to better accommodate the device.

- Cut out the bottle nozzle and plug the hole with electrical tape.

- Make the holes (according to the place where the support will be installed on the bike) to cross the ziptie.

Put your device into the mount and utilizing rubber band (from old inner tube) fix it.

- utilizing zip tie, Clip the mount in the chosen location.

that's all folks! ;)