DIY FLASH DIFFUSER
A FLAH DIFFUSER MAED FROM PLASTIC LAMPSHADE
Stuff You Need
some wood,I used 180mm plywood.
a plastic lampshade.
and the flash you want to defuse.
4 small screws
PWOER TOOLS !!
drill, saw and sander.
a plastic lampshade.
and the flash you want to defuse.
4 small screws
PWOER TOOLS !!
drill, saw and sander.
Mark It
mark the outline of the lamp on the plywood,
center the flash inside and mark it too.
center the flash inside and mark it too.
Drill It
drill the inside of the flash outline, you need a big drill bit
to fit the saw in.
to fit the saw in.
Clamp and Saw
clamp the plywood and saw the hole for the flash.
then saw the outline of the lamp.
then saw the outline of the lamp.
Send It
now you need to send it until it fits in the lamp and the flash fits inside.
Drill It Again
now it's time to secure the plywood to the lampshade.
drill 4 holes, 2 in each side and screw in the screws.
drill 4 holes, 2 in each side and screw in the screws.
That's It You Are Done !
