DIY Insta360 Go 2 Charger

My insta360 go 2 wasn't charging for quite some time, it's been more than a year so insta360 support won't replace my charging case. Anyway I tried support, they ask me to reset the device and case for 1 or 2 times and my case won't charge my go 2 regularly. I should keep a pressure or hold in a way to charge the device completely.

And this was annoying when my device is able to record only 1-2 min max at 30 sec per clip, I can't do longer clips. I stumbled upon online to get in hand in one of their USB Power mounts that has an option to charge the device without the charging case. But my bad luck, I can't find a single one because there is already a new model insta360 go3 and go3s where Launched.

I tried to build my own version of USB Power mount. BUY one of these .

3D print one of these mount and alien the contact pin to exact location

Use a hot glue or use a superglue to fix it to the mount.

join the positive negative to a USB type A.

plug the USB a to a power source 5V, Powerbank also works