DIY Paper Airplane Launcher

Today I will show you how to make a very fun and easy DIY Paper Airplane Launcher!

This project I will be showing you uses household supplies that everyone has and flies really great

To have the most fun with this project use it outside!

A Peace of Cardboard

Scissors

Tape

Rubber Band

3 Q-Tips

Hot Glue/Hot Glue Sticks

Twine/Thin Rope

Spray Paint (Optional)

You will need to cut the piece of cardbord to 5" X 10.5"

Cut 1 Q-Tip like I did

Cut 2 Q-Tips like I did

Lay out the Q-Tips in a tryangle with the 2 longer ones together and the short one on the other side

Use a pencil to poke a hole whare the Q-Tips are, then pud the Q-Tips in them in there (It is ok if thay are not straight up)

Now just pud the hot glue around the rods and hold them straight up for 5 min

Get 2 wooden dowels (around 8"long 1/4" thick) and glue/tape like I did

This will help to keep it from collabsing and to make the plane go straight

For taping down the rubber band you want to tape it in the front for the rails so that the plane does not get stuck

Tie the rope on to itself with the circle being about an 1" big now cut the rope with 3" left

When ever you reload it pud the rope around rubber band or else it will NOT work

The best Paint to use is acrylic

Good job!