DIY Ric Rac Ribbon Rose

by Praveena Ravishankar in Craft > Jewelry

2635 Views, 67 Favorites, 0 Comments

DIY Ric Rac Ribbon Rose

DSC04711.JPG

This DIY brings you how to make a Ric Rac Ribbon rose earring. In addition, this DIY will show you how to use bead cap as a Filigree!

Materials Required

DSC04676.JPG

Ric Rac ribbon

Bead caps

Pearls

Headpins

Earring hooks

glue, tools (not pictured)

Cut Your Ribbon in Half. Take One Half and Fold It Into Half.

DSC04679.JPG

Alternate the Waves on to Each Other, Just Rotate Each Half on to the Other, in an Alternate Fashion.

DSC04681.JPG
DSC04683.JPG

This Is How It Should Look Like Now. Seal the Ends Using Lighter, Use the Blue Flame for Clear Sealing

DSC04685.JPG
DSC04684.JPG

Now, Keep Your Needle and Thread Ready. (I Chose a Matching Color)

DSC04688.JPG

Start Rotating From the Middle Towards End. Just Stitch for Every Once in a While to Make Sure the Flower Stays in Place. (you Can Use Fabric Glue If You Are Allergic to Sewing.

DSC04690.JPG
DSC04691.JPG

In the End, Push the Last Piece on the Back of Rose. This Will Be Your Back. Here Is Your Finished Rose. I Made 2.

DSC04697.JPG

Now, Use Your Bead Cap As Filigree

DSC04700.JPG

Just open the bead cap ends using pliers and it will fan out as a filigree. Paste your flowers on to the filigree.

https://craftornothing.wordpress.com/2014/05/16/bead-cap-as-filigree/ - this shows u how to make bead cap as filigree.

Add Your Pearl

DSC04709.JPG
DSC04707.JPG
DSC04705.JPG
DSC04703.JPG

Take a filigree and glue your rose back to the filigree.
Take a headpin, and add your pearl. Now bend the wire at 90 degrees. Cut extra and turn into a loop using round nose pliers.

Using the Same Technique, Add Your Earring Hook.

DSC04713.JPG

Your ric rac ribbon rose earring is ready :)