Dart Board

I decided to make something that could be fun to play with. What I decided to make is a dart board.

My supplies to make it, was a computer to make the 3D model and a 3D printer to put it up in display.

1) The first step was to get a cylinder and make it as wide as the grid then make the height smaller.

2) The second step was to get another cylinder and make it smaller than the first cylinder to be able to put the numbers on the outside.

3) Third step get a cylinder and make it a lot smaller than the previous ones to make the green part of the board.

4) Fourth step get another cylinder and make it about half the size of the green piece.

5) Fifth step is to make a ring around the red circle and the green circle to make a replica of the metal ring.

6) Sixth step was to make the pieces where the darts will land, the triangles. Get a roof from the basic shapes section and start playing around with it until you get it right all around.

7) Step seven the final step is to put the numbers in each section of the cylinder lining.