Design and Assemble a Wheelchair Lever Arm: Bottom Stacked Gear
by issylapearson in Workshop > 3D Printing
406 Views, 0 Favorites, 0 Comments
Design and Assemble a Wheelchair Lever Arm: Bottom Stacked Gear
Instructions on how to build part of the wheelchair lever arm in solidworks for this project:
Go Up to Step 4 on This Instructable to Create an Identical Gear Base and Rotate It 180 Degrees
https://www.instructables.com/id/Design-and-Assemble-a-Wheelchair-Lever-Arm-Top-Sta/
Sketch a Circle With Diameter 106mm on the Front Face of the Gear and Use "Boss Extrude" to Extrude It 10mm
Draw a Circle With Diameter 75mm, Draw a Circle Along That Line With Diameter 5.45mm and Use "Circular Pattern" to Create 3 Equal Holes
Use "Hole Wizard" to Create an M5 Counterbore Hole in the Center
History Tree
