Design and Assemble a Wheelchair Lever Arm: Top Stacked Gear

by issylapearson in Workshop > 3D Printing

603 Views, 0 Favorites, 0 Comments

Design and Assemble a Wheelchair Lever Arm: Top Stacked Gear

3.Final.png

Instructions on how to build part of the wheelchair lever arm in solidworks for this project:

https://www.instructables.com/id/Design-and-Assemb...

Sketch a 126mm Diameter Circle on the Front Face

3.1.png

Draw a Centerline Vertical to the Top of the Circle, Then Use "Straight Line" and "Spline" to Create a Tooth

3.2.png

Use "Circular Pattern" to Create 35 Teeth Around the Circle and Use "Trim" to Trim the Edge

3.3.png

Extrude the Gear for 10mm

3.4.png

Draw a 107mm Diameter and a 119mm Diameter Circle on the Front Face of the Gear, Extrude the Space Between for 10mm

3.5.png
3.6.png

Redraw the 107mm Diameter Circle and Use It to "Extrude Cut" All the Way Through the Gear

3.7.png
3.Final.png

History Tree

Design Tree.png