Dremel Saw Table

How to Make a Dremel Saw Table.

- dremel
- 2•2 sheet of plywood
- T square
- hinge
- latch
-

Cut out wood to the following measurments (all in inches)

All half inch plywood
2-6&1/2
6&1/2-8&3/4
Four 4&3/4-1&1/4
6&1/2-11

All quarter inch thick
2&1/2-11 with a 1&1/2 by 2 rectangle taken out of one corner.
1&1/4-9
11-1&1/4 with a 1/2-2 rectangle taken out of one of the corners.

Cut a groove for the hinge 3 inches away from the end of the (1&1/4-11) you cut. Then screw the hinge in the groove, then screw the (1&1/4-9) on top of that.

Cut notches in two of the ( ) to hold the back end of the dremel, and the other two for the front end of the dremel.

Assemble the pieces together to form the holder.

Get the only piece left, that is your saw table. I

And you are done.