Drill Powered Bottle Opener

This was a fun project and very quick to make. Measurements are not critical so have a play around and see what works best ! if you do make it then please send me an email or a message on YouTube I would love to see it ! or comment below under the "I made it " option.

Here is the video incase it doesn't show https://www.youtube.com/watch?v=3fEXC8rKJAA

I first cut a bit of beech approx 40 x 40 then I drilled a slightly offset hole to accept a coach bolt I then tightened it down with a nut and washer I then drove in two washer head screws, I used some sheet metal screws as they had a flat head for grip on the bottle cap but it took a while to drive them in because of the metal predrill profile on the end.

In the video to test it out I found I needed it on speed one on the highest torque and by just pressing the trigger slowly with better practise this could be done a lot quicker by and would be really impressive !

Please drink responsibly and have fun !