Easy Marshmallow Shooter

Here are instructions to make a simple marshmallow shooter that anyone can make with simple tools and PVC pipe.

Materials

Required:

1 Long section of 1/2" diameter PVC pipe.
2 T connecters
1 Pipe cutter
1 Nickel
1 Bag of mini marshmallows

Use a pipecutter to cut the PVC. Mouseover the parts below to see approximate lengths of each pipe.

Place Nickel in T Connector

Place the nickel inside the bottom hole of one of the T connectors. This part will be where you place the handle of the gun and seals the barrels of the shooter.

Add the Handle to the T

Insert the 4" PVC pipe to the bottom of the T connector where you placed the nickel.

Adding the Mid Section of the Barrel

Next, insert the 4" PCV pipe into the T connector. This is the middle part of the shooter barrel.

Adding the Mouth Piece

Then, insert the 2" PCV pipe (mouth piece) to the open end to the T connector.

Adding the Second T Connector

Place the second T connector on the end of the mid barrel section. The T connector should have the middle hole facing up and tilted slightly to the left or right side depending on which hand you prefer to use when loading marshmallows.

Add Ammo Clip

Insert a 4.5" section into the top of the T connector you just added. This is where you will load the marshmallows.

Add the Rest of the Barrel

Add the last section of PVC pipe onto the T connector. The shooter is now complete and ready for marshmallow action.

Loading the Shooter

Insert mini marshmallows into the ammo clip.

Fire When Ready!

You are now ready for the marshmallow amageddon.