Electronic Component Sculptures

Hello everybody,

Today I'm gonna publish a new instructable, in which I will be showing you how to make sculptures out of electronic components. I think these sculptures suits your worktables perfectly. You can find old components in junk PCBs or you can take new components too.

1. Resistors
2. Capacitors
3. Inductors
4. Trimpots
5. ICs
6. (or any other electronic components)
7. Soldering iron and accessories

clean the component terminals and apply a little bit of solder. Also use flux if required.

follow the pictures in the correct order to make it. small disc capacitors are twisted to resistors terminals to make hand and foot

Take an 8 pin IC (NE555, uA741C, etc) and solder 8 resistors to its terminals as shown. Then bend it to make the 8 legs of the spider. use a disk capacitor to make the head.

Take a 3 pin IC (78XX, 79XX, etc) and use the pins as shown to make the man.

Now we have completed the sculpture and these are better gifts to offer to your electronics loving friends. You can see an additional man in the picture shown above. try to make it and think out of the box to make wonderful sculptures. Enjoy making.