FOREHEAD HUNTING LIGHT (Rechargeable)

Hi Instructables, in My First Instructable Project I was design a High Bright Hunting Head Light using waste Torch Light With 4v rechargeable battery. The original Fore Head Light costs $6-$7, but these lights costs less than $ 2 and also makes recycle the torch. I make this project similar with ultra bright led emergency lamp by ASCAS

TOP USES:
1. Night Guide Light
2. Hunting Light
3. Search Light

Gathering Tools & Materials

Materials:

-1W Ultra Bright LED
-Red LED Indicator(Here I am using white LED)
-Resistor (100-300 ohm)
-1N 4007 Rectifier Diode
-DC Power Jack (Female Port)
-4v Lead Acid Battery (Normal China Made Battery)
-Wire (Twisted)
-Old or Damaged Torch Light (China Made Torch Light)
-Elastic Belt
-Cloth Belt (Or Old Back Bags Adjusting Rope)
-Rivets (Available in Normal Stationary Shops)

TOOLS&EQUIPMENT:

-Soldering Iron
-Soldering Wire
-Hot Glue Gun
-Wire Cutters
-Hacksaw Blade
-Screw Driver
-Insulating Tape

REMOVE THE WASTE PARTS FROM TORCH LIGHT

1. Remove the top and bottom parts of the Torch Light
2. Make small cut on both sides of neck of the Torch Light head

INSERT THE ELASTIC BELT INTO TORCH LIGHT HEAD

1. Remove the clip on anyone side of the Elastic Belt.
2. Insert the Elastic Belt through the cut on torch Light Head.
3. Again place the clip using the Rivets

STEP 4: MAKE THE SUPPORT USING CLOTH BELT

1. Connect the one end of Cloth Belt on back side of the Torch Light by using small Iron Piece.
2. Connect the other end of the Cloth Belt to Elastic Belt

MAKE THE RECHARGEABLE LIGHT

1. Make Soldering as per this schematic diagram. For the switch we use the switch of the Torch Light.
2. Place the 1W LED on illuminating part of the torch light using the glue gun.
3. Place the circuit on inside of the neck of the Torch.
4. Place the dc port on side of the torch light neck.
5. Place the Battery on clip of the Elastic Belt using long wire.
6. Place the indicating LED on anyone viewing side.
7.Gluing all the parts.

CONNECT AND FINISH

1. Join the top and bottom side of the Torch Light using Glue Gun and Insulating Tape.
2. Finish the work and Charge the battery and use it.
3. Wear the light on head by adjusting two belts.
Press the button and Enjoy yourself.

WEAR LIKE THIS

Place the light on Head like this.

The power of this Light is similar to the ultra bright led emergency lamp by ASCAS

power of this light