Fallout 4 3D Printed Pip-Boy

This is a 3D print I did when i got a new 3d printer and it took about 20-28 hours to print all the parts.

After all the pieces are printed go to http://ytec3d.com/pip-boy-3000-mark-iv-assembly/ and it will show you what goes where. I have used blue tack until i find the right screws,bolts and screws.

If you wish to use black or white with the filament i would advise that you paint it, But remember that you don't have to paint it green. If you wish to have a white and red Pip-Boy to show that you are part of the Institute then you may. Let your imagination go wild.