Flower Pot Stand
I wanted to make Indoor Flower pot Stand from the scrap
wooden baton strips of 40 mm width and 5 mm thick strips
1) I cut these strips of 400 mm length- 12 No's ( White strips as seen in snap -2 )
and 220 mm length strips-4 No's ( Black strips as seen in snap -2 )
2) Nailed 3 White strips parallel at there center on the Black strips with a gap of 25 mm
Made such 4 assembly's as seen in snap-3
3) Now all the 4 assembly's White strips are nailed on the edges at all 4 corners
to form a square of 400 mm length as seen in snap-4
4) Now We can put Indoor Pot inside this square Stand
It is simple,cheap and looks beautiful !
wooden baton strips of 40 mm width and 5 mm thick strips
1) I cut these strips of 400 mm length- 12 No's ( White strips as seen in snap -2 )
and 220 mm length strips-4 No's ( Black strips as seen in snap -2 )
2) Nailed 3 White strips parallel at there center on the Black strips with a gap of 25 mm
Made such 4 assembly's as seen in snap-3
3) Now all the 4 assembly's White strips are nailed on the edges at all 4 corners
to form a square of 400 mm length as seen in snap-4
4) Now We can put Indoor Pot inside this square Stand
It is simple,cheap and looks beautiful !