Ford Ranger 2.5" Leveling Kit Install 2019-2022

Freddy from PoorManMods shows you how to install a Rough Country 2.5" Leveling kit for the 2019-2022 Ford Ranger

Get the leveling kit here

Remove the 4 skid plate bolts

Disconnect the 3 connectors

Remove ABS sensor bracket and sensor, then the brake hose bracket

Disconnect the tie rod and sway bar from steering knuckle

Disconnect upper ball joint from steering knuckle

Remove the 2 bottom and 3 top nuts securing the strut

Use a pry bar and push down on the lower control arm to remove the strut

lightly torch the lower strut bolts and hammer them out

Install the provided studs into the strut spacer

Install the spacer onto the top of the strut with the 3 factory nuts, then place the strut back into the truck

Install the 2 lower strut bolts, lightly tap them into the strut until they stop, then spray some lubricant onto the splines. Install the 2 nuts on the bottom and tighten them to draw the bolts through the strut and properly tightening them.

This part can be tricky, but pull down on the upper control arm and install the nut onto the ball joint

Install the 3 provided nuts onto the strut studs

Finally, reconnect the tie rod, sway bar, brake hose and ABS sensor.