Fully-Automated Nerf Stephan Cutter (FANSC)
by maxxxem in Living > LEGO & K'NEX
3696 Views, 1 Favorites, 0 Comments
Fully-Automated Nerf Stephan Cutter (FANSC)
Using Lego NXT i made a machine that cuts FBR into similar lengths
About 1.3-1.5inches
This is in the prototype stage
The programming was simple
-Loop
- motor A,B sipn and slide fbr forward
-motor C cuts it
the only problem is that the blanks are not cut prefectaly flat (10degrees)
About 1.3-1.5inches
This is in the prototype stage
The programming was simple
-Loop
- motor A,B sipn and slide fbr forward
-motor C cuts it
the only problem is that the blanks are not cut prefectaly flat (10degrees)