HOMEMADE CLAW MACHINE

This is the second and new Version of my Claw Machine (Old Version)

As I announced in my first Version, the "new" Machine will be painted and setted up with an Arduino.

These are the most important parts I bought for the Claw Machine V2:

Arduino MEGA, 2x 8 Arduino Relays, Mp3 module, accessories like cables and resistors

Wood colour grey, yellow, green, black

Claw Machine Assembly / Gantry

I built the keypad out of OSB-wood and I drilled some holes for the Speaker. Then I painted it and prepared the cables.

I had some ideas for the Color design so I first tried it out in google sketchup.

As I used LEGO in my last machine for the Gantry, I now buyed a cheap one of a German Arcade shop.

I rewired the whole Assembly for my purposes and added a Printer Port cable for easy plug and unplug. Watch the pictures to get yourselfes inspired.

̶i̶̶ ̶̶a̶̶m̶̶ ̶̶s̶̶e̶̶l̶̶l̶̶i̶̶n̶̶g̶̶ ̶̶m̶̶y̶̶ ̶̶o̶̶l̶̶d̶̶ ̶̶c̶̶l̶̶a̶̶w̶̶!̶̶ ̶̶i̶̶f̶̶ ̶̶y̶̶o̶̶u̶̶ ̶̶a̶̶r̶̶e̶̶ ̶̶i̶̶n̶̶t̶̶e̶̶r̶̶e̶̶s̶̶t̶̶e̶̶d̶̶,̶̶ ̶̶w̶̶r̶̶i̶̶t̶̶e̶̶ ̶̶m̶̶e̶̶ ̶̶a̶̶ ̶̶p̶̶r̶̶i̶̶v̶̶a̶̶t̶̶e̶̶ ̶̶m̶̶e̶̶s̶̶s̶̶a̶̶g̶̶e̶̶.̶ SOLD!

In the Pictures you can see the assembled Claw Gantry and the Field for the Prices. There is a Printer Cable for easy plug and unplug the whole Gantry.

Now I tested the Motors of the Gantry, because it was selled as "not tested". But as you can see in the Video, e.g the up/down motor works, as well as the X and Y motor.

The most difficult part of this project is the programming. In the pictures you can see a few impressions of the Arduino setup. The PDF file is the Logic program that runs on the Arduino. All in all it is about 350 lines of code.