Handle Adaptor

by zihanx7 in Workshop > 3D Printing

71 Views, 0 Favorites, 0 Comments

Handle Adaptor

Resulting figure for handle adaptors.PNG

Handle Adaptor

​Handle Adapter History Tree

Handle Adaptor history tree.PNG

This is the history tree or our handle adapter. Units are all in MMKG.

Handle Adaptors base sketch.PNG

Create a sketch in the front plane. Draw a circle, one with diameter 21.18mm.

Handle Adaptors #3.PNG

Extrude the circle to 50mm.[Boss-Extrude1]

Create a reference place located at a distance 30 mm from the bottom surface of the extruded circle. [Plane 1]

Handle Adaptors #4.PNG

Create a sketch at the bottom of the extruded circle, and draw a circle with diameter 32mm.

Handle Adaptors #5.PNG

Create a new sketch on the plane 1, and draw a circle with diameter 22mm.

Handle Adaptors #6.PNG

Use loft, selecting two sketches created in step#4 & step#5. [Loft2]

Handle Adaptor#7.PNG

Create a new sketch at the plane 1, and draw a circle with diameter 22mm.

Handle Adaptor#8.PNG

Extrude out to 150 mm.[Boss-Extrude2]

Handle Adaptor#9.PNG

Create a reference plane ,by setting two references, face1 and the top plane, that are parallel to each reference.

Handle Adaptor#10.PNG

Create a new sketch on plane 2, and draw a circle with diameter 6.25 mm, located at 25 mm from the top edge.

Extrude cut through the sketched circle. [Cut-Extrude1]

Resulting figure for handle adaptors.PNG

This is our resulting figure for the handle adapter