How To: Create a Half Tester Style Bed Canopy
by The Dolls House Emporium in Living > Decorating
5037 Views, 9 Favorites, 0 Comments
How To: Create a Half Tester Style Bed Canopy
Begin by customising the Red Velvet Curtains 5777 by removing the gold fringe around the pelmet.
Then cut off the shaped front of the pelmet using a pair of scissors to straighten it off. Tuck the remaining fabric under the pelmet to create a straight pelmet front.
Then cut off the shaped front of the pelmet using a pair of scissors to straighten it off. Tuck the remaining fabric under the pelmet to create a straight pelmet front.
Then strengthened the pelmet by adding a Timber Length 5995 to the back of the front of the pelmet - I secured it using a hot glue gun.
WARNING! Be Careful not to burn your fingers when using a hot glue gun as the heat carries through the fabric.
WARNING! Be Careful not to burn your fingers when using a hot glue gun as the heat carries through the fabric.
Now that the pelmet is ready, it’s time to add the additional height to the Contemporary 4 Poster Bed 2290
Please be aware! You must measure the ceiling height of the room you intend to put your Contemporary 4 Poster Bed 2290 into as you are adding additional height to the bed.
Other things to consider include whether the room has a ceiling light - and if the walls have cornice - as both may have an impact on the ceiling height: remember, you may have to get the canopy bed past the ceiling light!
Once I measured the height of the room I cut up two pieces of Timber Length 5995. I then glued these to the head posts of the bed using a hot glue gun.
WARNING! Be Careful not to burn your fingers when using a hot glue gun.
Please be aware! You must measure the ceiling height of the room you intend to put your Contemporary 4 Poster Bed 2290 into as you are adding additional height to the bed.
Other things to consider include whether the room has a ceiling light - and if the walls have cornice - as both may have an impact on the ceiling height: remember, you may have to get the canopy bed past the ceiling light!
Once I measured the height of the room I cut up two pieces of Timber Length 5995. I then glued these to the head posts of the bed using a hot glue gun.
WARNING! Be Careful not to burn your fingers when using a hot glue gun.
Once I was happy that the glue had set I attached the customised Red Velvet Curtains 5777 to the bed again using a hot glue gun.
Meanwhile, to finish off the front of the pelmet I cut some more Timber 5995 and I stained the pieces using a small brush and dark wood stain.
Once this was dry I attached it to the front of the pelmet to finish off.
Your Half Tester Style Bed Canopy is now complete, Well Done!
Meanwhile, to finish off the front of the pelmet I cut some more Timber 5995 and I stained the pieces using a small brush and dark wood stain.
Once this was dry I attached it to the front of the pelmet to finish off.
Your Half Tester Style Bed Canopy is now complete, Well Done!