How to Make a Starburst Rubber Band Bracelet

You will need:
Any loom
A hook
70 bands
A c or s clip

Place one band from the bottom peg to the next top peg.

Place one band from the first peg to the next peg.

Continue this up the whole side of the loom.

On the last peg, turn in.

Go back to the first peg. Turn out to the first peg.

Repeat

Place one band from the middle pin to the next pin. Repeat this step in a clockwise direction.

This is what your loom should look like.

Place a cap band on the last peg.

Place another cap band in the center of the starburst.

Do this to the rest of the starburst.

Loop the bottom band to the center of your burst.

Go into the middle peg and grab the top band. Loop it to the corresponding peg. Keep doing this in a counter clockwise direction.

After you loop the last band. Go to the top peg if your burst. Grab the next color of band on the bottom pull it over and loop it on itself.

Once you finish looping the bursts, loop your boarder bands. Start by looping out.

Once you finish, stick your hook through all the bands at the top of your loom.

Place a single band on the end of your hook. Pull the band through. Now you can pull your bracelet off the loom. You can add adjusters and your done! I hope you enjoyed this! Bye!