How to Paint a Skateboard
Stencil
For this project I needed a stencil and I saw something called stencil tape at Michael's, but its basically masking tape so you can use that. So I just went down the board and covered it in the tape
Draw on Your Design
I eyeballed my design so I took a sharpie and just drew it on.
Begin Cutting Your Design
To cut it out i used an x-acto knife and just cut on the lines i drew.
Preparing to Paint
Make sure you are outsides or in a well ventilated area because the paint can be toxic
Painting
For the paint i used Valspar Plastic Spray Paint. I got it from AC Moore for under ten bucks. I didn't feel like taking off my trucks so I covered it in newspaper on the grass. I stood about afoot or so away and sprayed over the board. I used about three coats I think.
Finished!
After it dried I took off the stencil and it was done!