How to Make Pallet Wood Slab From Recycled Materials

by Omer O in Workshop > Woodworking

7779 Views, 74 Favorites, 0 Comments

How to Make Pallet Wood Slab From Recycled Materials

IMG_8501.JPG
Instructebale Pallet Slab  1000x1000.jpg

In this Instructable, I make a wood slab for an old Singer sewing machine table that I renovated.
Most of the wooden beams were dismantled from old wooden pallets.

In the center of the slab are three broomstick rods, which help unit all the beams together.

You're invited to subscribe to my YouTube channel and follow all of my projects:

https://www.youtube.com/channel/UCkNrUodcQbCM8FDGp...

Facebook: https://www.facebook.com/kultakaladesign/

Your support is much appreciated! New projects coming soon!

Measuring and Marking Before Cutting

1.png
2.png

Make sure you don't use chemically treated wood.

made sure to pull out all the nails so there would be no problems cutting & drilling.

Cut to Desired Size

3.png
4.png

Mark Three Lines

5.png
6.png
8.png
7.png
9.png

I set up the planks in the order I liked, and I numbered them.

I've mark three lines across all the planks, This lines will be used to determine the position for broomsticks that will be Going through all the planks.

Marking a Location for Drilling

11.png
10.png

Drilling

12.png
13.png
14.png
15.png

I used a drill bit that much the broomsticks diameter.

All the beams are drilled all the way, only The outer beams were drilled halfway,

That way, the broomsticks won't be exposed, they won't be seen.

Preliminary Match Test

16.png
17.png
18.png

Before using glue, I checked that broomsticks easily pass through all the Wooden beams.

Glue the Boards

19.png
20.png
21.png
22.png

Eventually, the boards are glued all together.

Held with clamps for 48 hours.

Milling the Wood

23.png
24.png
25.png

I Temporarily glued the Slab to the table with a double-sided adhesive so it wouldn't move during milling.

Later on, I also added wedges.

And the Other Side...

26.png
27.png
28.png
29.png
30.png

Cutting Edges

31.png
32.png
33.png

To get a clean, straight line, I sawed the edges With a circular saw.

Sanding & Filling Cracks

34.png
35.png
36.png

First, I used Rough sanding paper and sand all the surfaces, then In the cracks, I applied wood filling.

After the drying, I sand it all again with Fine Paper.

Painting

37.png
39.png
38.png

I painted it all with matte varnish.

Assembly

40.png
41.png
42.png
IMG_8459.JPG

I attached the slab to a sewing machine table legs that I recently renovated.

Final Result

IMG_8495.JPG
IMG_8498.JPG
IMG_8497.JPG
IMG_8496.JPG

Hope you enjoy the project documentation - if there are any questions or comments I'd love to hear.
Thank you :)

Tools and Materials:

IMG_6177.JPG

Drill press, router, router sled, Circular Saw, orbital sander, clamps, paintbrush, spatula, Goggles, Gloves, Sanding paper, Varnish, Wood glue, Wood Filling, broomsticks, Pallet wood.