Cardboard Phone Stand With Charging Slot

This project was my first instructable. The holder can hold a phone or a tablet. It can also be used to hold pencils, rulers and more.

• thin Cardboard
• Scissors
• Hot Glue or Duct Tape
• Paint (optional)
• Charging wire and phone

Cut out the parts. The two long pieces should be about 4 inches by 1 inch, while 4 of the small pieces should be about 1 and 1/2 inches by 1 inch. The last 2 small pieces should be about 1 and 1/2 inches by 1 and 1/4 Inches.

For this step, I glued on the front panels first. You can use hot glue or duct tape.

The back support was too short, so the phone flipped backwards

I added more back support and angled the front panel down more.

This time, it worked.

For the next few steps, we will be adding parts for the stand to be able to have a wire.

Cut out the pieces. They should be the same as the first cutting.

Add the back panel on top of the original back panel. Also add the front panel on top of the original front panel. Make the second layer by placing the 2 small panels as the floor. You can also add diagonal small panels like in the photo. Don’t forget to add supports if it falls over

You can paint the stand if you want.

You now have a cardboard phone stand.