How to Make a Stealth Paper Airplane

This set of instructions should allow you to create a 'stealth' paper airplane.

Materials needed:

-8.5x11 inch paper (1 for each plane desired)

-Scissors

-Tape

This may seem self-explanatory, but the number of people who get frustrated in their inability to make a paper airplane simply because they are folding something other than paper, be it cardboard or dirt or yesterday's leftovers is staggeringly high.

So do it right by getting an actual piece of 8x11 inch paper.

Fold the paper in half vertically, as shown.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Take the tips of the top side, and fold them down at a 45-degree angle so that they meet in the middle.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Fold the upper bit of your paper down so that there is about a 3/4 inch gap between the tip and the bottom of your piece of paper.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Fold the top tips down so that they meet in the middle, similar to an earlier step.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Fold the small triangular tip up so that it overlaps the other two tips you folded down in the previous step.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Flip the whole paper over and fold your paper in half like shown, so that the small triangular tip you folded up in the last step is visible on the outside. If you can no longer see the small triangular tip after you did this step you folded it inside out.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Fold only 1 of the wings down as shown.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Repeat the previous step on the opposite wing. You will have to flip the plane to the other side to get the proper angle to fold it.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Place a small piece of scotch tape across the bridge of the plane, on the 'x'. This should stabilize the plane, keeping the wings out horizontally across from each other.

Fold up the end portions of each wing slightly, so that they stand vertically as shown. This is more so it looks cool than anything.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Using scissors, cut 2 slits on both wings, near the tip, and then slightly fold up the cut portion. Be careful to not cut the slits too far.

Note: The green line shows the current step, any black line shows previous steps. The left picture is before, the right picture is after.

Congrats, you folded a (hopefully) cool looking airplane! Celebrate by throwing it at someone, but don't blame me if they get mad at you.