How to Make a Fence Is SketchUp

First Open SketchUp on your computer.

Click on the Unnamed button on the top left corner of the page.

Then type the title you would like and click okay.

Click on the file you would like to have your SketchUp saved.

Select the guy and press backspace.

Go through the toolbar on the left and open the rectangle tool.

click and then move the mouse. This will make a rectangle.

Type the dimensions needed which is: 3.5,8'

Press Enter.

Go to the toolbar on the left side and select the Push/Pull tool.

Click on the face of the 4x8 and slide up then type 1.5.

Right-click the pice and click make a component.

Click Okay on this page.

Make a 2x3 inch rectangle.

Make it 3/4'' tall.

Right click and click "make component".

Make a rectangle 2'x5 1/2.

Make it 3/4'' tall and make it a component.

Get the pencil tool and build this with the dimensions.

Make it 3/4'' tall and make it a component.

Use the pencil tool to make this shape.

Make it 3/4 inch tall make it a component.

Use the pencile tool to make this shape.

Make it 3/4'' tall and make it a component.

Make an 8'x4'' Rectangle.

Make it 1/2'' tall make it a component.

Make a 2'x4'' rectangle.

Make it 1/2'' tall and make it a component.

Lay the cross pieces with the top dimensions like this. First foam upright 3.5'' away from the end and 1.5'' above the cross piece. All of the others go on every 2''s. and then 3.5'' from other ends.

Copy the cross piece and put it 4'' from the bottom of the foam up right.

Select this setup and right click then click make a component.

click the protractor on the toolbar on the left.

Click on the bracket.

Turn this bracket by 90 degrees.

Get the move tool and move the bracket to the fence and put one bracket on each side of foam set up.

Select the whole set up with the bracket's and right click then clicks mack group.

Select foot holder.

Get the move tool and move the foot holder to the center of the base.

Use the rotate tool and rotate the rectangle 90 degrees.

Move the rectangle on top of the base and in the foot holder.

select and rotate the upright.

Move the upright to in front of the rectangle.

Make this set up a group.

Move the 2x4 to the upright as shown in the picture.

Copy the 2x4 and put on on the bottom as shown.

Copy support.

Spinn the upright so that it will fit for the opposit side.

Move the support so it is in behined the 2x4. Then make this whole set up a group.

Get the Rotate tool and spin the fence cover so that it is vertical.

With the move, tool move the fence cover so that the hooks are around the 2x4.

Draw a line with the line tool straight out from the side of the fence that is 5' long.

Select the whole first fence and copy it. Move the copy to the end of the line.

This gives you two fences that have a cover.