How to Use Button Module With SkiiiD

This project is an instruction of "how to use Buzzer HW-508(applicable for KY-006) with Arduino via skiiiD

Before start, below is a basic tutorial for how to use skiiiD

Launch SkiiiD

Launch skiiiD and select New button

Select ① Arduino Uno and then click ② OK button

*This is Tutorial, and we use Arduino UNO. Other boards(Mega, Nano) have the same process.

Click '+' (Add Component Button) to search and select the component.

① Type 'Button' on the search bar or find the Buzzer module on the list.

② Select Button Module

then you can see ③ pin indication. (You can configure it.)

*This module has 3 pins to connect

skiiiD Editor automatically indicate pin setting *configuration available

[Default Pin Indication for Button Module] in case of Arduino UNO

Signal: 0

VCC: 5V

GND: GND

After configuring pins ④ click ADD button on the right below side

⑤ Added Module has appeared on the right panel

skiiiD Code is intuitive function-based codes. This is based on skiiiD libraries

isClicked() - This code shows 1 as clicked status, and 0 as unclicked status.

We are working on components and boards libraries. Feel free to use it and welcome to feedback. Below is contact methods

email: contact@skiiid.io

visit https://skiiid.io/contact/ and go to Need help tab.

Comments are fine too!