How to Use MotordriverL298N With SkiiiD

This project is an instruction of "how to use Segment 3642BH with Arduino via skiiiD

Before start, below is a basic tutorial for how to use skiiiD https://www.instructables.com/id/Getting-Started-With-SkiiiD-Editor/

Launch SkiiiD

Launch skiiiD and select New button

Select ① Arduino Uno and then click ② OK button

*This is Tutorial, and we use Arduino UNO. Other boards(Mega, Nano) have the same process.

Click '+' (Add Component Button) to search and select the component.

① Type 'motor' on the search bar or find the MotordriverL298N on the list.

② Select MotordriverL298N Module

then you can see ③ pin indication. (You can configure it.)

*This module has 8 pins to connect

skiiiD Editor automatically indicate pin setting *configuration available

[Default Pin Indication for MotordriverL298N Module] in case of Arduino UNO
5V: 5V

GND: GND

ENA: 3

IN1: 0

IN2: 1

IN3: 2

IN4: 4

ENB: 5

After configuring pins ④ click ADD button on the right below side

⑤ Added Module has appeared on the right panel

skiiiD Code is intuitive function-based codes. This is based on skiiiD libraries

RotateA()

"Change speed and direction of motor connected with OUT1 and OUT2 pin.

Speed default: 100, Range: 0~100

Enter 1 on direction to change direction of the motor, default is 0."

RotateB()

"Change speed and direction of motor connected with OUT3 and OUT4 pin.

Speed default: 100, Range: 0~100

Enter 1 on direction to change direction of the motor, default is 0."

RotateAB()

"Change speed and direction of two motors simultaneously.

Speed default: 100, Range: 0~100

Enter 1 on direction to change direction of the motor, default is 0."

We are working on components and boards libraries. Feel free to use it and feedback us, please. Below is contact methods

email: contact@skiiid.io

Comments are fine too!