How to Use Segment 3642BH With SkiiiD

by skiiiD in Circuits > Arduino

787 Views, 0 Favorites, 0 Comments

How to Use Segment 3642BH With SkiiiD

skiiiD - Easiest way to code Segment 3642BH on Arduino.

This project is an instruction of "how to use Segment 3642BH with Arduino via skiiiD

Before start, below is a basic tutorial for how to use skiiiD https://www.instructables.com/id/Getting-Started-With-SkiiiD-Editor/

Launch SkiiiD

FGHQAU7K3XFNO18.LARGE.jpg

Launch skiiiD and select New button

Select Arduino UNO

FWOCQ92K3XFNO1V.LARGE.jpg

Select ① Arduino Uno and then click ② OK button

*This is Tutorial, and we use Arduino UNO. Other boards(Mega, Nano) have the same process.

Add Component

FXZ9VESK3XFNO29.LARGE.jpg

Click '+' (Add Component Button) to search and select the component.

Search or Find a Component

F8Y23LTK3XFNO3D.LARGE.jpg

① Type 'RGBLed' on the search bar or find the Buzzer module on the list.

Select Segment 3642BH

skiiiD (Latest Version - 0.1.16) 12_17_2019 2_07_42 PM.png

② Select Segment 3642BH Module

Pin Indication and Configuration

skiiiD (Latest Version - 0.1.16) 12_17_2019 2_07_51 PM.png

then you can see ③ pin indication. (You can configure it.)

*This module has 4 pins to connect

skiiiD Editor automatically indicate pin setting *configuration available

[Default Pin Indication for Button Module] in case of Arduino UNO

CLK: 0

DIO: 1

VCC: 5V

GND: GND

After configuring pins ④ click ADD button on the right below side

Check Added Module

skiiiD (Latest Version - 0.1.16) 12_17_2019 2_08_03 PM.png

⑤ Added Module has appeared on the right panel

SkiiiD Code of Segment Module

skiiiD (Latest Version - 0.1.16) 12_17_2019 2_08_48 PM.png

skiiiD Code is intuitive function-based codes. This is based on skiiiD libraries

clear() - Clear display.

setColon() - Initialize colon on the center of the segment.

If 'mode' is equal to 0, colon is off.

If 'mode' is equal to 1, colon is on.

Default: off or 0.

setBrightness() - Set brightness of the segment.

The range of brightness is 0~7 and the default is 2(BRIGHTNESS_NORMAL).

displayNumber() - number': Display 4-digit positive number or 3-digit negative number.

Contact and Feedback

We are working on components and boards libraries. Feel free to use it and feedback us, please. Below is contact methods

email: contact@skiiid.io

twitter: https://twitter.com/skiiiD_official

Youtube: https://www.youtube.com/channel/UCfS2RQL3m3hVoHkFo...

Comments are fine too!